— LED Wall · Outdoor
Unilumin Upad IV 2.6 preset: cabinet grid & viewing distance
Problem. A 6 x 3.375 m (16:9) outdoor wall built from the Unilumin Upad IV 2.6 has to resolve to a whole number of cabinets, which shifts the actual finished size away from the target dimensions. The real sizing decision is working out that cabinet grid and its native resolution before committing to a footprint, and confirming the closest seat sits inside the pitch's optimal viewing band rather than too close for the content to resolve cleanly.
Answer. At this target size the Upad IV 2.6 resolves to a 12 x 7 cabinet grid, giving an actual wall of 6 x 3.5 m rather than the nominal 6 x 3.375 m. That grid delivers a native resolution of 2304 x 1344 (approximately 3.1 MP), which the calculator uses to size type, motion graphics, and video content correctly for the closest seat.
02 / In depth
How this preset reads — the engineering view.
The 2.6 mm pixel pitch is the number both the cabinet grid and the viewing band are built from: at 2.6 mm, the optimal viewing distance for video content runs from roughly 2.6 m to 5.2 m (pitch x 1.0 to pitch x 2.0). Inside that band the pixel structure disappears into a clean image; closer than 2.6 m individual pixels start to read as a grid rather than a picture.
7000 nits is an outdoor brightness figure, built to stay legible against direct sun rather than the dim ambient light of an indoor stage or lobby, so this preset assumes an uncovered or partially shaded outdoor site rather than an indoor fit-out. Front-service access means cabinets can be maintained from the viewing side, which matters where there is no rear walkway, and the rental-frame chassis is built for repeated installs and strikes rather than a single permanent fixed build. The native 2304 x 1344 output (about 3.1 MP) suits broadcast-style video, motion graphics, and mixed content at this size rather than fine small-type reading distances.
Drag the wall width and height sliders to see the cabinet grid and native resolution recompute in real time. Because cabinets are a fixed physical unit, the calculator snaps your target dimensions to the nearest whole cabinet count, so the actual wall reported may differ slightly from the size you dragged to — that is expected, not an error.
The calculator sizes the wall and checks the viewing band; it does not decide structural or rigging load for the frame and cabinets, the power and data cable runs back to distribution, the video processor or scaler needed to feed the panel at its native resolution, how source content should be mapped or scaled onto 2304 x 1344, or ambient-light calibration for the specific site. Those need a site-specific engineering review.
What this preset deliberately does not solve
- The 2.6-5.2 m viewing band is a general pitch-based guideline (pitch x 1.0 to x 2.0), not a fixed rule for every content type or ambient light condition.
- Cabinet snapping means the actual built wall is very slightly larger than most target dimensions entered; treat the calculator's output size as the one to plan around, not the typed-in target.
- Brightness, viewing distance, and resolution figures are manufacturer-stated specifications for this model and do not account for a specific site's sun angle, shading, or local dust and heat exposure.
How this preset differs from its siblings
The Upad IV 2.6's 2.6 mm pitch sits it closer to the screen than coarser outdoor pitches (such as 4 mm or 6 mm products), which pulls its optimal viewing band nearer and raises its native resolution per square metre for the same wall size. Its 7000-nit outdoor brightness and front-service, rental-frame configuration also differ from indoor fixed-install LED products, which typically run lower brightness and rear-service access. This preset exists separately because pitch, brightness, and service method all change the sizing and viewing-distance math, so a generic outdoor LED preset would not reflect this specific cabinet's numbers.
03 / Hydrated calculator
Try the configuration — live.
The calculator below is preloaded with this preset’s state. Adjust any input — your URL stays shareable.
— Calculator · LED wall size
The wall built cabinet by cabinet.
Pick a brand, model, wall dimensions and viewing distance. Cabinet count, native resolution, power, weight and feasibility flags resolve in real time. Sources cited.
Cabinets
84
12 across × 7 down
Native resolution
2304 × 1344
3.1 megapixels
Actual wall
6.00 m × 3.50 m
21.0 m² · cabinet-snap
A planning link — not a quote.
- model
- Unilumin Upad IV 2.6 — P2.6 outdoor
- pitch
- P2.60 mm
- brightness
- 7,000 nits
- refresh
- 3,840 Hz
- viewing
- 2.60 m – 5.20 m optimal
- weight
- 588 kg
- power
- avg 5.88 kW · peak 16.80 kW
- ip rating
- IP65 (front) / IP54 (rear)
Outdoor rental staple. High brightness, IP65 front. Default for daytime outdoor LED installations.
Indicative cabinet build for shortlisting — confirm structure, power and processing against a site survey before ordering.
What changes this estimate
- Actual viewing distances in the room
- Pixel pitch availability in the chosen series
- Content type (data, video, fine text)
- Mounting structure & cabinet dimensions
Feasibility
At 15.00 m viewing, a coarser pitch would deliver the same perceived resolution at lower cost.
Cabinet grid resolves to 6.00 m × 3.50 m (target was 6.00 m × 3.38 m).
A planning link — not a quote.
· Other presets for led wall size calculator
LED Wall · Hospitality Lobby
Hotel lobby video wall — 4 × 2 m, 2.5 mm pitch
A premium hotel lobby wants a 4 × 2 m video wall for brand storytelling viewable from 4–8 m as guests circulate.
LED Wall · Corporate Stage
Conference stage backdrop — 6 × 3 m, 2.6 mm pitch
A 6 × 3 m stage backdrop for hybrid conferences needs to read clearly on stage and on broadcast camera without moiré.
LED Wall · Fine-pitch indoor
Samsung The Wall IWA (P1.68) — cabinet grid & viewing distance
A controlled indoor space wants a 4 x 2.25 m video wall built from Samsung The Wall IWA (P1.68) fine-pitch cabinets, and needs to know how the cabinet grid, native resolution and closest comfortable seat resolve before the wall is specified. The decision hinges on how tightly a 1.68 mm pitch can be viewed and how many cabinets the target wall actually needs.
LED Wall · All-in-one
Samsung The Wall All-in-One IWA: cabinet grid & viewing distance
A 3.6 x 2.03 m (16:9) wall is a common starting point for a boardroom or lobby display, but the right cabinet grid and closest-seat distance depend on the specific product's pixel pitch and packaging. This preset works through that sizing for the Samsung The Wall All-in-One IWA, an all-in-one, front-service cabinet at 1.68 mm pixel pitch.
LED Wall · Fine-pitch indoor
LG MAGNIT LSAB (P0.9) cabinet grid & viewing distance
A 4 x 2.25 m video wall in a controlled indoor space needs a cabinet grid that lands close to the target dimensions without odd part-cabinet edges. At 0.9375 mm pixel pitch, the sizing decision also has to keep the closest seat far enough back that individual pixels disappear into a clean image.
LED Wall · Fine-pitch Indoor
LG MAGNIT LSAA (P1.5) — cabinet grid & viewing distance
A 4 x 2.25 m indoor video wall (16:9) needs a fine-pitch cabinet that stays sharp for viewers as close as 1.6-3 m without the cabinet grid or native resolution becoming a guessing game before procurement.
LED Wall · Fine-pitch indoor
Leyard DirectLight X (P1.2) — cabinet grid & viewing distance
A fine-pitch indoor LED wall needs a cabinet grid and viewing envelope that match the room, not just a target width and height. At a 4 × 2.25 m (16:9) wall, the decision is how the DirectLight X's 1.27 mm pitch maps to cabinet count, native resolution and the distance at which the closest seat can sit.
LED Wall · Mid-pitch indoor
Leyard CarbonLight CLF-2.5 cabinet grid & viewing distance
A 5 x 2.8 m indoor wall needs a cabinet layout that lands close to the target size without odd part-cabinet edges, and a closest-seat distance that keeps the pixel structure invisible rather than a visible grid. Getting both right up front avoids a re-order once the cabinet count and viewing zone are fixed on site.
LED Wall · Fine-pitch indoor
Absen N1.5 Pro cabinet grid & viewing distance
A fine-pitch indoor wall built from Absen N1.5 Pro cabinets needs its cabinet grid and native resolution confirmed before layout is locked, and its closest comfortable seat needs checking against the cabinet's 1.56 mm pitch. A 4 x 2.25 m (16:9) target is the common starting footprint for this class of wall.
LED Wall · Outdoor
Absen A27 Plus — cabinet grid & viewing distance
An outdoor screen at 6 x 3.375 m (16:9) needs a cabinet grid that lands close to the target size without odd fractional cabinets at the edges, and a viewing distance where the pitch reads clean rather than pixelated. For direct-sun outdoor use the brightness budget also has to be settled alongside the size decision, not after it.
LED Wall · Fine-pitch indoor
Unilumin UMiniIII 1.2 — cabinet grid & viewing distance
A 4 × 2.25 m indoor video wall needs a fine-pitch cabinet that stays crisp for viewers who won't stand back far — corporate lobbies, control rooms and boardrooms typically watch from inside 3 m. The sizing question is which cabinet grid actually fits the target wall and what native resolution that grid delivers before any content or mounting decision is made.
LED Wall · Fine-pitch indoor
Christie Velvet Apex II 1.5: cabinet grid & viewing distance
A 4 x 2.25 m (16:9) indoor wall needs a cabinet layout that lands close to the target size without the calculator quietly rounding away the difference. Christie Velvet Apex II 1.5, at 1.56 mm pixel pitch, resolves this by snapping the requested area to a whole-cabinet grid and reporting the actual built dimensions and native resolution alongside it.
LED Wall · Fine-pitch Indoor
Barco XT 1.5 — cabinet grid & viewing distance, 4 × 2.25 m
A controlled indoor space wants a 4 × 2.25 m (16:9) video wall built from Barco XT 1.5 cabinets, and needs to know the resulting cabinet grid, actual wall size and native resolution before committing to a mount plan.
LED Wall · Broadcast / rental
ROE Visual Black Pearl BP2V2 — cabinet grid & viewing distance
A production team specifying a 5 x 3 m Black Pearl BP2V2 wall needs the exact cabinet grid, native resolution and optimal camera-to-wall viewing band before confirming a rental order.
LED Wall · Fine-pitch indoor
ROE Visual Ruby RB1.5: cabinet grid & viewing distance
A 4 x 2.25 m (16:9) wall built from ROE Visual Ruby RB1.5 cabinets must resolve to a whole number of cabinets in each direction, so the finished wall is rarely the exact target size. The real design decision is how the cabinet grid, actual wall dimensions, and native resolution settle out, and whether the intended closest-seat distance sits inside this pitch's optimal viewing band.
LED Wall · Fine-pitch indoor
INFiLED DB Series P1.9 — cabinet grid & viewing distance
A 4 × 2.25 m indoor video wall needs a fine-pitch cabinet that stays crisp for viewers who may approach within a few metres, without over-specifying beyond what the room requires. The INFiLED DB Series P1.9's 500 mm cabinet module has to tile cleanly across that footprint while the pitch is checked against the intended closest-seat distance.
LED Wall · Outdoor
Daktronics DVN Outdoor P6.6 — cabinet grid & viewing distance
An outdoor video wall sized at roughly 6 x 3.375 m (16:9) needs a cabinet grid that lands on whole cabinets and a pitch that reads clearly from the intended viewing distance in direct sunlight. Daktronics DVN Outdoor P6.6 is a 6.6 mm outdoor cabinet rated to 6500 nits, and this preset checks how it resolves against that target wall.
LED Wall · Fine-pitch indoor
Planar TVF Series P1.5 — cabinet grid & viewing distance
A controlled indoor environment wants a 4 x 2.25 m (16:9) video wall built from Planar TVF Series P1.5 cabinets, and needs to know how many cabinets are needed, what the actual finished wall size will be, and how close viewers can sit before pixel structure becomes visible.
LED Wall · Fine-pitch indoor
Sony Crystal LED BH P1.5 — cabinet grid & viewing distance
A fine-pitch indoor wall built from Sony Crystal LED BH P1.5 cabinets needs a defensible cabinet grid before anyone commits to a 4 x 2.25 m (16:9) opening, since fine-pitch panels are sized and priced by the cabinet, not the metre.
· Next
Brief us on the project — with this configuration.
Presets are a typology starting point. The brief wizard captures the room geometry, programme and constraints we need to translate this configuration into a real design.