— LED Wall · Fine-pitch indoor
Samsung The Wall IWA (P1.68) — cabinet grid & viewing distance
Problem. A controlled indoor space wants a 4 x 2.25 m video wall built from Samsung The Wall IWA (P1.68) fine-pitch cabinets, and needs to know how the cabinet grid, native resolution and closest comfortable seat resolve before the wall is specified. The decision hinges on how tightly a 1.68 mm pitch can be viewed and how many cabinets the target wall actually needs.
Answer. At a 4 x 2.25 m target, the calculator resolves a 5 x 5 cabinet grid, producing an actual wall of 4.03 x 2.27 m. That grid natively renders 2400 x 1350 pixels (approximately 3.2 MP), which the tool checks against the pitch-derived viewing band.
02 / In depth
How this preset reads — the engineering view.
Pixel pitch is the single number that drives both outputs on this page. Samsung The Wall IWA carries a 1.68 mm pitch, which the calculator uses to size the cabinet grid against the 4 x 2.25 m target and to derive the optimal viewing band for video content, approximately 1.7-3.4 m (roughly 1.0 to 2.0 times the pitch in metres). The default closest seat in this preset is set to 3 m, inside that band.
At 1600 nits, this cabinet is specified for controlled indoor environments rather than daylight-facing glazing or direct sun exposure — the brightness headroom is for contrast and colour consistency under typical indoor lighting, not for outdoor legibility. The listing is wall-mount, front-service, which affects how much clearance the installation needs behind the wall versus in front of it. At the preset's 5 x 5 grid, the native canvas of 2400 x 1350 (~3.2 MP) suits high-detail video and broadcast-style content viewed from a few metres, rather than large-venue signage viewed from a distance.
To use the calculator, drag the wall width and height and watch the cabinet grid and native resolution recompute live. Cabinets are fixed-size modules, so they snap to whole units — the actual wall the tool reports (4.03 x 2.27 m here) will usually differ slightly from the target you dragged to (4 x 2.25 m), and that small difference is expected, not an error.
The calculator sizes the cabinet grid, native resolution and viewing-distance band only. It does not decide the structural or rigging load the wall imposes on the supporting wall or frame, the power and data cabling run between cabinets and the controller, the video processor or scaler needed to feed the wall, how source content resolution maps onto the native 2400 x 1350 canvas, or ambient-light calibration for the room the wall sits in. Each of those is a separate engineering step once the cabinet grid is confirmed.
What this preset deliberately does not solve
- The 5 x 5 cabinet grid is derived from the target wall size; changing the target by even a small margin can shift the grid to a different cabinet count.
- The actual wall dimension (4.03 x 2.27 m) reflects cabinet snapping and will not exactly match a hand-picked target size.
- The 1.7-3.4 m viewing band is a pitch-derived guideline for video content, not a guarantee of legibility in every room's lighting and seating layout.
How this preset differs from its siblings
This cabinet's 1.68 mm pitch sits tighter than typical corporate or hospitality fine-pitch products, which changes both the cabinet count for a given wall size and the closest comfortable viewing distance compared with coarser-pitch fine-pitch indoor products. Its 1600-nit brightness and front-service, wall-mount profile are also specified for a controlled indoor setting with rear or limited service access, which is a different installation and maintenance profile from cabinets built for brighter rooms or rear-service access. This preset exists to give this specific cabinet its own defensible grid-and-distance answer rather than folding it into a generic fine-pitch indoor preset.
03 / Hydrated calculator
Try the configuration — live.
The calculator below is preloaded with this preset’s state. Adjust any input — your URL stays shareable.
— Calculator · LED wall size
The wall built cabinet by cabinet.
Pick a brand, model, wall dimensions and viewing distance. Cabinet count, native resolution, power, weight and feasibility flags resolve in real time. Sources cited.
Cabinets
25
5 across × 5 down
Native resolution
2400 × 1350
3.2 megapixels
Actual wall
4.03 m × 2.27 m
9.1 m² · cabinet-snap
A planning link — not a quote.
- model
- Samsung The Wall IWA — P1.68
- pitch
- P1.68 mm
- brightness
- 1,600 nits
- refresh
- 3,840 Hz
- viewing
- 1.68 m – 3.36 m optimal
- weight
- 347 kg
- power
- avg 2.37 kW · peak 5.48 kW
Premium MicroLED IF cabinet. Front-serviceable, HDR10+ and Dolby Vision support, broadcast-grade refresh.
Indicative cabinet build for shortlisting — confirm structure, power and processing against a site survey before ordering.
What changes this estimate
- Actual viewing distances in the room
- Pixel pitch availability in the chosen series
- Content type (data, video, fine text)
- Mounting structure & cabinet dimensions
A planning link — not a quote.
· Other presets for led wall size calculator
LED Wall · Hospitality Lobby
Hotel lobby video wall — 4 × 2 m, 2.5 mm pitch
A premium hotel lobby wants a 4 × 2 m video wall for brand storytelling viewable from 4–8 m as guests circulate.
LED Wall · Corporate Stage
Conference stage backdrop — 6 × 3 m, 2.6 mm pitch
A 6 × 3 m stage backdrop for hybrid conferences needs to read clearly on stage and on broadcast camera without moiré.
LED Wall · All-in-one
Samsung The Wall All-in-One IWA: cabinet grid & viewing distance
A 3.6 x 2.03 m (16:9) wall is a common starting point for a boardroom or lobby display, but the right cabinet grid and closest-seat distance depend on the specific product's pixel pitch and packaging. This preset works through that sizing for the Samsung The Wall All-in-One IWA, an all-in-one, front-service cabinet at 1.68 mm pixel pitch.
LED Wall · Fine-pitch indoor
LG MAGNIT LSAB (P0.9) cabinet grid & viewing distance
A 4 x 2.25 m video wall in a controlled indoor space needs a cabinet grid that lands close to the target dimensions without odd part-cabinet edges. At 0.9375 mm pixel pitch, the sizing decision also has to keep the closest seat far enough back that individual pixels disappear into a clean image.
LED Wall · Fine-pitch Indoor
LG MAGNIT LSAA (P1.5) — cabinet grid & viewing distance
A 4 x 2.25 m indoor video wall (16:9) needs a fine-pitch cabinet that stays sharp for viewers as close as 1.6-3 m without the cabinet grid or native resolution becoming a guessing game before procurement.
LED Wall · Fine-pitch indoor
Leyard DirectLight X (P1.2) — cabinet grid & viewing distance
A fine-pitch indoor LED wall needs a cabinet grid and viewing envelope that match the room, not just a target width and height. At a 4 × 2.25 m (16:9) wall, the decision is how the DirectLight X's 1.27 mm pitch maps to cabinet count, native resolution and the distance at which the closest seat can sit.
LED Wall · Mid-pitch indoor
Leyard CarbonLight CLF-2.5 cabinet grid & viewing distance
A 5 x 2.8 m indoor wall needs a cabinet layout that lands close to the target size without odd part-cabinet edges, and a closest-seat distance that keeps the pixel structure invisible rather than a visible grid. Getting both right up front avoids a re-order once the cabinet count and viewing zone are fixed on site.
LED Wall · Fine-pitch indoor
Absen N1.5 Pro cabinet grid & viewing distance
A fine-pitch indoor wall built from Absen N1.5 Pro cabinets needs its cabinet grid and native resolution confirmed before layout is locked, and its closest comfortable seat needs checking against the cabinet's 1.56 mm pitch. A 4 x 2.25 m (16:9) target is the common starting footprint for this class of wall.
LED Wall · Outdoor
Absen A27 Plus — cabinet grid & viewing distance
An outdoor screen at 6 x 3.375 m (16:9) needs a cabinet grid that lands close to the target size without odd fractional cabinets at the edges, and a viewing distance where the pitch reads clean rather than pixelated. For direct-sun outdoor use the brightness budget also has to be settled alongside the size decision, not after it.
LED Wall · Fine-pitch indoor
Unilumin UMiniIII 1.2 — cabinet grid & viewing distance
A 4 × 2.25 m indoor video wall needs a fine-pitch cabinet that stays crisp for viewers who won't stand back far — corporate lobbies, control rooms and boardrooms typically watch from inside 3 m. The sizing question is which cabinet grid actually fits the target wall and what native resolution that grid delivers before any content or mounting decision is made.
LED Wall · Outdoor
Unilumin Upad IV 2.6 preset: cabinet grid & viewing distance
A 6 x 3.375 m (16:9) outdoor wall built from the Unilumin Upad IV 2.6 has to resolve to a whole number of cabinets, which shifts the actual finished size away from the target dimensions. The real sizing decision is working out that cabinet grid and its native resolution before committing to a footprint, and confirming the closest seat sits inside the pitch's optimal viewing band rather than too close for the content to resolve cleanly.
LED Wall · Fine-pitch indoor
Christie Velvet Apex II 1.5: cabinet grid & viewing distance
A 4 x 2.25 m (16:9) indoor wall needs a cabinet layout that lands close to the target size without the calculator quietly rounding away the difference. Christie Velvet Apex II 1.5, at 1.56 mm pixel pitch, resolves this by snapping the requested area to a whole-cabinet grid and reporting the actual built dimensions and native resolution alongside it.
LED Wall · Fine-pitch Indoor
Barco XT 1.5 — cabinet grid & viewing distance, 4 × 2.25 m
A controlled indoor space wants a 4 × 2.25 m (16:9) video wall built from Barco XT 1.5 cabinets, and needs to know the resulting cabinet grid, actual wall size and native resolution before committing to a mount plan.
LED Wall · Broadcast / rental
ROE Visual Black Pearl BP2V2 — cabinet grid & viewing distance
A production team specifying a 5 x 3 m Black Pearl BP2V2 wall needs the exact cabinet grid, native resolution and optimal camera-to-wall viewing band before confirming a rental order.
LED Wall · Fine-pitch indoor
ROE Visual Ruby RB1.5: cabinet grid & viewing distance
A 4 x 2.25 m (16:9) wall built from ROE Visual Ruby RB1.5 cabinets must resolve to a whole number of cabinets in each direction, so the finished wall is rarely the exact target size. The real design decision is how the cabinet grid, actual wall dimensions, and native resolution settle out, and whether the intended closest-seat distance sits inside this pitch's optimal viewing band.
LED Wall · Fine-pitch indoor
INFiLED DB Series P1.9 — cabinet grid & viewing distance
A 4 × 2.25 m indoor video wall needs a fine-pitch cabinet that stays crisp for viewers who may approach within a few metres, without over-specifying beyond what the room requires. The INFiLED DB Series P1.9's 500 mm cabinet module has to tile cleanly across that footprint while the pitch is checked against the intended closest-seat distance.
LED Wall · Outdoor
Daktronics DVN Outdoor P6.6 — cabinet grid & viewing distance
An outdoor video wall sized at roughly 6 x 3.375 m (16:9) needs a cabinet grid that lands on whole cabinets and a pitch that reads clearly from the intended viewing distance in direct sunlight. Daktronics DVN Outdoor P6.6 is a 6.6 mm outdoor cabinet rated to 6500 nits, and this preset checks how it resolves against that target wall.
LED Wall · Fine-pitch indoor
Planar TVF Series P1.5 — cabinet grid & viewing distance
A controlled indoor environment wants a 4 x 2.25 m (16:9) video wall built from Planar TVF Series P1.5 cabinets, and needs to know how many cabinets are needed, what the actual finished wall size will be, and how close viewers can sit before pixel structure becomes visible.
LED Wall · Fine-pitch indoor
Sony Crystal LED BH P1.5 — cabinet grid & viewing distance
A fine-pitch indoor wall built from Sony Crystal LED BH P1.5 cabinets needs a defensible cabinet grid before anyone commits to a 4 x 2.25 m (16:9) opening, since fine-pitch panels are sized and priced by the cabinet, not the metre.
· Next
Brief us on the project — with this configuration.
Presets are a typology starting point. The brief wizard captures the room geometry, programme and constraints we need to translate this configuration into a real design.